Re: TI-H: Re: networking
[Prev][Next][Index][Thread]
Re: TI-H: Re: networking
ok cause its really slow now that i'm on 100mb, it was faster on my 10base2,
so explain in detail what i need to do and where(running 75-100ft string
lengths)
-Dan
thedew@usit.net
----- Original Message -----
From: "Olle Hedman" <oh@hem.passagen.se>
To: <ti-hardware@lists.ticalc.org>
Sent: Saturday, December 18, 1999 11:13 PM
Subject: Re: TI-H: Re: networking
>
> Actually, if you should be fully correct, the ground cable (thats the
striped
> one) of the two middle pairs, should switch place with eachother at both
sides.
> The cable will still be straight through, but the impedance (hmm.. don't
really
> know the correct english word) will change.
> An expensive cabletester will find this (very common) error.
> It doesn't really matter with short cables, but when you go up to be close
to
> the limits (80m-100m), you will experience problems.
> If you run 100Mbit, it could also be a good idea to do it really right, to
gain
> maximum speed.
>
> file://Olle
>
> Kaus wrote:
> > no. no. you did fine. you see, it depends on the configuration you use.
>
>
Follow-Ups:
References: