Re: TI-H: $5 Parellel Link

[Prev][Next][Index][Thread]

Re: TI-H: $5 Parellel Link

Do as I did, cut your TI<->TI link in half, and solder a 3.6mm male to the other half and a 3.6mm female to the other, now you can make all your addons using a 3.6mm male plug (the half with the female end also works directly as a speaker adapter..) =), and when you need a TI<->TI link, just plug the halves together, works fine with me... =)
 
       Markus Räty
(markus.raty@usa.net)
----- Original Message -----
From: J. Kaste
To: ti-hardware@lists.ticalc.org
Sent: 15. huhtikuuta 1999 4:34
Subject: TI-H: $5 Parellel Link

I built the $5 Parellel Link a while back and have really stoped using it becasue it takes arround 1.5 or 2 hourst to send a 1 or 2KB file.  Is this really normal?  It seems like a lot of time.  I sometimes have batteries die in the middle transfering a program.  I am using a TI-83, and I just used a pack of the only silicon diodes available at Radio Shack.  I also put a 3.5mm female jack on the link, used a 3.55mm to 2.55mm adaptor and then plugged into my calc with the TI-to-TI link, can this effect it.  I dont want to cut my only link but if this will speed it up I will order another.
 
Thanks for your time,
Garrett Kaste.
References: