Re: TI 85 radian/ Degree help.


[Prev][Next][Index][Thread]

Re: TI 85 radian/ Degree help.



Theres a couple of ways to do it - go to radians mode type in your #
followed by the degree symbol to get into radians.  to get back to
degrees change the mode back to degrees place the radian "r" (located
right next to the degree symbol) symbol after
your answer this brings you back to your original # in degrees.


remember:            x/2pi = 37/360       so    x = 2pi(37/360),  x

is in radians

to go back             (x/2pi)*360 = 37  (assuming of course your
                                                           using x = .645...)

Hope this helps - I reccommend using the formula I've provided and
writing a program if your going to be using this often!
-CMB