Re: $4 link
[Prev][Next][Index][Thread]
Sohan Japa wrote:
> Could someone please give instructions on how to build a circuit. I would
> like to build the $4 link, but I have very little experiance in building
> circuits. The only thing I have done is built a radio with a radio kit.
> I have already read the directions for the $4 link, but they seem
> complicated. Could someoone simplify them for me. Do you put the circuit
> on a some kind of board? How do you connect the circuit, are there wires?
I don't know a lot about circuit building either, but I managed to build
a perfectly working $4 link. I only used the components listed in the
schematic, and a little serial port connector. No additional wire was
needed as I soldered the leads of the components and the the wire out of
the TI-TI link together. I didn't use a board so that I could place the
whole link in a shrink tube which made it look really nice. I also found
that the people working at Radio Shack are very nice and will help you
figure out what to do.
Good luck!
<pre>
--
Colin Dewey
Email: TIguy@poboxes.com
Homepage: http://www.geocities.com/SiliconValley/5691/
</pre>
References: