[A83] Re: Getting the current flash page
[Prev][Next][Index][Thread]
[A83] Re: Getting the current flash page
> Actually, 4C4Bh is FindAppDn, not 4C45h. 4C45h will get you the current
> flash page, but I'm unsure as to why you would want to spend three bytes
> using a B_CALL, instead of two bytes using an input.
't was for TI's programming contest, which states that you may not read/write
directly from the calcs hardware...
I already solved the problem another way, but thanks anyway.
--(Peter-Martijn)
>
> -Dan Englender
>
> ----- Original Message -----
> From: "Edgar Phelps" <edthief69@yahoo.com>
> To: <assembly-83@lists.ticalc.org>
> Sent: Tuesday, August 14, 2001 11:01 AM
> Subject: [A83] Re: Getting the current flash page
>
>
> >
> > 4C45h is FindAppDn, which ,according to the
> > developer's guide, doesn't give any information about
> > the ROM page. Try B_CALL FindApp (FindApp is 4C4Eh).
> >
> > HTH
> > Ed
> > --- Michael Vincent <hookman@worldnet.att.net> wrote:
> > >
> > > I'm not sure if this is documented as an equate or
> > > not, but B_CALL 4C45h
> > > will return the current flash page in A.
> > >
> > >
> > > Michael Vincent
> > > Detached Solutions - www.detacheds.com
> > > Radical Software - www.radicalsoft.org
> > >
> > > ----- Original Message -----
> > > From: "Peter-Martijn Kuipers"
> > > <hyper@hysoft-automation.com>
> > > To: <assembly-83@lists.ticalc.org>
> > > Sent: Tuesday, August 14, 2001 12:25 AM
> > > Subject: [A83] Getting the current flash page
> > >
> > >
> > > >
> > > > How do I get the current flash page an application
> > > is using,
> > > > WITHOUT using the input/output ports?
> > > > (So, how do I do it with a bcall?)
> > > >
> > > > --(Peter-Martijn)
> > > >
> > > >
> > > >
> > >
> > >
> > >
> >
> >
> > __________________________________________________
> > Do You Yahoo!?
> > Make international calls for as low as $.04/minute with Yahoo! Messenger
> > http://phonecard.yahoo.com/
> >
> >
>
>
>
References: