Re: A83: Re: Matrices and Lists...
[Prev][Next][Index][Thread]
Re: A83: Re: Matrices and Lists...
hmm rst 56d? u mean rst 56b? it should be rst 38h. all the calculators use
the same rst commands because they use the same processor
>Oh please! I thought this list was for programming the ti-83, not the
z80...
>RST means restart, but it isn't a good name. It can jump to some predefined
>addresses (f.ex. 0000, don't remember the others), and the whole
instruction
>is only one byte long. This makes it somewhat easier in interrupt mode 0,
>where the interrupting device places an instruction on the data bus. RST 0
>would reset the calculator, since this is where the processor will go when
you
>power it on (new batteries). RST 56d is used in interrupt mode 1 (which the
>ti-83 uses) for all interrupts.
Follow-Ups: