Re: TI-H: networking
[Prev][Next][Index][Thread]
Re: TI-H: networking
Oh, you use Protel also? I love Protel
BTW, What happened to your website Grant?
----- Original Message -----
From: Grant Stockly <gussie@stockly.com>
To: <ti-hardware@lists.ticalc.org>
Sent: Sunday, December 19, 1999 3:29 PM
Subject: RE: TI-H: networking
>
> Ok. I'll draw it up in Protel on my way to fairbanks tomorow.
>
> I designed it to act as a 3 port hub for an ethernet telephone.
>
> Grant
>
>
> >I am interested in seeing your hub diagram Grant.
> >
> >Brenden McNeil
> >Microsoft Certified Professional
> >A+ Certified Service Technician
> >bmcneil@delanet.com
> >Fax: (305) 675-0871
> >AOL Instant Messenger: mcneil1458
> >ICQ: 9155183
> >http://www.bmcneil.com
> >
> >
> >> -----Original Message-----
> >> From: owner-ti-hardware@lists.ticalc.org
> >> [mailto:owner-ti-hardware@lists.ticalc.org]On Behalf Of Grant Stockly
> >> Sent: Sunday, December 19, 1999 4:00 AM
> >> To: ti-hardware@lists.ticalc.org
> >> Subject: Re: TI-H: networking
> >>
> >>
> >>
> >> >OK, I happen to be a certified network guy. The cheapest way is
> >> to set up a
> >> >10base2 network. One t connector for each card, two terminators
> >> (1 for each
> >> >end) and a coax (RG-58) cable between the cables.
> >>
> >> The cheapest way still isn't 10Base-2. Look at current hub prices.
> >>
> >> I've wired ethernet runs using phone wire, so $.12-.20 coax isn't
needed.
> >> Good ethernet cards come with patch cables anyway. There isn't that
much
> >> signal loss (much less than that of a kinked coax cable) and with
> >> the speed
> >> of hubs...not noticable.
> >>
> >> >Then there is 10baseT. 10baseT cards can be found by the dozen. you
can
> >> >hook up two computers with a cross over cable (pins 1 &3, and
> >> pins 2&6 are
> >> >switched, i.e. RX and TX) But you can buy a small hub pretty cheaply.
A
> >> >while ago I bought a 4 port NetGear Hub for $35.
> >>
> >> Many sell for $19.99. And...you can alaways make your own.
> >>
> >>
>
>
>
References: