Re: TI-H: Port voltage


[Prev][Next][Index][Thread]

Re: TI-H: Port voltage




So how would I go about determining if its 1 or 0?  Do these 1 and 0s come in multiples of 4 to create a byte? and what is the alternate method you refered to as tips?  

Thanx vb5man@usa.net

*********** REPLY SEPARATOR ***********

On 10/24/98, at 3:38 PM, Grant Stockly  wrote: 

>>Does the TI link port have a certain voltage for each character sent
>>during a transmission?
>>If not, how could I interprete the data using circuitry or voltage?
>
>No.  Its not an analogue signal.
>
>its either 1, or 0.  You have to either make a protocol or use tip.
>
>Grant


Follow-Ups: References: