Re: TI-H: EL Panel & MORE

To: ti-hardware@lists.ticalc.org
Subject: Re: TI-H: EL Panel & MORE
From: "ryan pogge" <ryanpogge@hotmail.com>
Date: Sun, 01 Mar 1998 19:19:13 PST
Reply-To: ti-hardware@lists.ticalc.org


ok well can i see a scematic and the program?


>>temp...heat same thing?
>
>I had some spare parts...one was called temp, aand the other heat...
>
>>pressure... did you realy , if so may i have the driver/plans?
>>i designed one with a motorolla pressure sensor and a 10 bit adc from
>>national....but i dont have a driver as i dont know assemblyl;)
>
>I use a program that reads the pins and reports the value...
>
>>>again...  I got my calc to do math!  :)
>>>
>>>yet another repost of a stupid remark...  :)  Well, look whos 
talking?
>>>I've made temp/pressure/heat/motion sensors for my calc...  why not
>>touch?
>>>
>>>Grant
>>>
>>>>go to ELLAMP.com
>>>>(or maybe it is ELLAMPS.com)
>>>>anyway, they sell two things: el lamps
>>>>AND a piece of clear glass that has a chip attached to it that 
senses
>>where on
>>>>the glass you are and sends a signal...  this would be great for an
>>ASM PAINT
>>>>program or something like that.  It would rule and it could be 
easily
>>>>installed..  (using the port)
>>>>check it out
>>>
>>>
>>>
>>
>>
>>______________________________________________________
>>Get Your Private, Free Email at http://www.hotmail.com
>
>
>


______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com