RE: TI-H: USB Link
[Prev][Next][Index][Thread]
RE: TI-H: USB Link
Not quite correct. I'm assuming you'd use NT here, so...
Any multi-threaded software will take advantage of the extra processor
whether it was written specifically to take advantage of an extra processor
or not.
w/o a dual proc, NT simulates multi-threading, but it's not true
multi-threading (running two tasks at the same time). However, w/ dual
proc, NT just spits the different threads off to different procs.
Sincerely,
Bruce
--
Bruce Christensen - mailto:bruce@iname.com - ICQ: 12635516
NEW! The Expander 2 - http://www.calamistrum.com/visualdesign/e2/
More than quadruple your calculator's memory for under $50!
TI Calculator Link Cables - http://www.calamistrum.com/visualdesign/link/
Customer Site - http://www.calamistrum.com/visualdesign/link/customer.html
> -----Original Message-----
> From: owner-ti-hardware@lists.ticalc.org
> [mailto:owner-ti-hardware@lists.ticalc.org]On Behalf Of
> JNoonan123@aol.com
> Sent: Thursday, August 20, 1998 6:22 PM
> To: ti-hardware@lists.ticalc.org
> Subject: Re: TI-H: USB Link
>
>
>
> Dual chip systems only run like u described on specifically
> written software.
> Most of the software made is made for single processors. In order for the
> seperation of tasks, it would require special software and
> drivers to detect
> and direct cpu traffic thus slowwing it down. ON software
> optimized for dual
> processors u will definitly reep the benifits but they are a rarity.
>
References: