A89: Re: com port problem

[Prev][Next][Index][Thread]

A89: Re: com port problem

i couldn't get the ti graph link to work under 2000 either; remember windows 2k is running under a protected mode and programs aren't allowed to directly access the hardware.
 
I have both Windows 2k and 98 on mine; They both run great.
----- Original Message -----
From: Brian Taylor
To: assembly-89@lists.ticalc.org
Sent: Thursday, September 14, 2000 11:18 PM
Subject: A89: com port problem

probably not the place to ask this, but i will anyways.
 
does anyone else have problems getting the graph link software from ti to work under win2k?
 
i was using win98 and then winme, and both of them worked fine when i had the com port set to com1. when i installed win2k (i installed it over winme), all my settings remained the same, as far as hardware and mostly software, but when i try to use the graph link software, no com port works. i have com1 and com2 in my hardware device manager, so i know they are there, and the properties of them says they are working fine. anyone know what to do about this?
 
/brian
Follow-Ups: References: