Re: A89: Re: 'Remote Mode'


[Prev][Next][Index][Thread]

Re: A89: Re: 'Remote Mode'




You mean I am supposed to enable remote mode again, and that will in fact
actually disable remote mode?

Bryan

----- Original Message -----
From: Jeff Tyrrill <jeff_tyrrill@msn.com>
To: <assembly-89@lists.ticalc.org>
Sent: Thursday, August 12, 1999 4:04 AM
Subject: RE: A89: Re: 'Remote Mode'


>
> On the original TI-92, the calc was unstable after apparently being taken
> out of remote mode by taking a battery out, because it is still sending
> output to the link port, just not waiting for input from the link port.
> Anything that causes the calc to run out of memory and give a TI-Basic
> Error: Memory will instead just crash the calc. Perform the procedure to
> enable remote mode again in order to disable it completely and
re-stabilize
> the calc. This is according to David Ellsworth's ti-bugs.doc file. Also,
my
> TI-92 didn't APD when it was in remote mode.
>
> -----Original Message-----
> From: owner-assembly-89@lists.ticalc.org
> [mailto:owner-assembly-89@lists.ticalc.org]On Behalf Of Bryan Rabeler
> Sent: Monday, August 09, 1999 5:43 PM
> To: assembly-89@lists.ticalc.org
> Subject: Re: A89: Re: 'Remote Mode'
>
>
>
> Well, after leaving my 89 on for another 10 minutes, I decided to take a
> battery out.  After I turned the calculator back on, it was out of remote
> mode and my programs were still there...
>
> Bryan
>
> ----- Original Message -----
> From: Bryan Rabeler <rabelerb@pilot.msu.edu>
> To: <assembly-89@lists.ticalc.org>
> Sent: Monday, August 09, 1999 6:11 PM
> Subject: Re: A89: Re: 'Remote Mode'
>
>
> >
> > How long does it take for the APD to set in?  My 89 has been idle for
more
> > than 10 minutes, and its still on..
> >
> > Bryan
> >
> > ----- Original Message -----
> > From: <AzNgUy66@aol.com>
> > To: <assembly-89@lists.ticalc.org>
> > Sent: Monday, August 09, 1999 5:41 PM
> > Subject: Re: A89: Re: 'Remote Mode'
> >
> >
> > >
> > > you get out of remote mode by just leaving it on until the apd turns
off
> > the
> > > calc.... then you turn the calc back on and it is out of remote mode
> > >
> > > =]
> > >
> > >
> >
> >
> >
>
>
>
>
>
>



Follow-Ups: References: